Code: Alles auswählen
# The address of the SB server to connect to. You shouldn't
# need to change this unless you're doing something incredibly
# unauthorized with our client! (Or if you're using a proxy.)
#
# Currently a ServerAddress of sbp.pns.net along with either
# ServerPort 80 or ServerPort 22 will allow you to go around
# most packet filtering firewalls. Try these if you experience
# difficulty connecting.
ServerAddress sb.pns.net
ServerPort 1717
# The username to use on the server. This MUST BE A VALID
# you will be denied blocks! If you wish, you can use the
# 'anonymous' username, but remember that you won't be able
# to view your individual performance statistics on the
# website since they'll be shared with everyone else using
# 'anonymous'.
#
# Team and Username should both be alphanumeric (no spaces,
# _, -, etc) and 16 characters or less. Usernames must
# be assigned by the online signup script at
# www.seventeenorbust.com but team names can be added w/o
# a signup and will be automatically tracked online
Username Pascal
# DO NOT leave Team blank. This causes errors on some systems.
# If you wish to not be on a team, leave it as Team (null)
Team Rechenkraft
# Controls the client's logging behavior. The client will
# either write its results to a logfile, to the console, or
# both. You can also define a maximum log size -- once the
# log reaches this size, old entries will be removed when
# new entries are added. MaxLogSize is measured in kbytes.
LogFile sclient.log
LogToConsole 1
MaxLogSize 1000
# The priority level to run at. The following values are
# defined; any other value will be ignored:
# 1 - realtime priority (NOT recommended)
# 2 - high priority
# 3 - normal priority
# 4 - low priority
# 5 - idle priority (recommended)
PriorityLevel 5
# The transmission of intermediate blocks is recommended if you
# have a constant internet connection. Even if you cannot
# connect for the intermediate block reports every time,
# computation will still continue, although it will pause
# breifly to try every hour or so.
# 1 - Enable
# 0 - Disable
Transmit 1
# MaxRetries and RetryWait define how the client handles block
# request or report failures. The client will retry a maximum
# of MaxRetries times (or infinitely if MaxRetries is 0). Once
# it exceeds this number, it will exit. After a failure, it
# will wait RetryWait seconds before retrying. (Please don't
# set this lower than 60 seconds, or you'll be hammering the
# server if it ever goes down!)
MaxReportRetries 0
MaxRetries 0
RetryWait 1200
Aber die Configdaten werden wohl die gleichen sein...
[/code]
